Product Info

• IMPORTANT: Currently the Activate Passes option will default to unmarked (off) whenever the Skycut is

first powered on. Thus, make a mental note (or, even better, put a Post-It note on your cutter) to turn this

option on when needed. Also, note that when this setting is activated, it will take precedence over the

Passes setting in SignMaster.

2.04 Presets

• Presets allow you to save your settings for a particular blade type or material.

2.04.1 Saving a Preset for a Blade Type

• Let’s say you conducted the calibration for Blade Offset in Section 2.03.3 and determined it to be 0.40 for

your red capped blade. To save this setting as a preset, use the following steps:

• Go to the Send to be Cut>Cutter Control window and click on the icon to the right of Blade Offset to open

the Blade Settings Library:

• In the Blade Settings Library, click on the + icon to the right of Description and a window will open where

you can enter the name for your new preset:

Open Blade Settings Library

Click on the Cutter Control tab

Use + and – buttons to enter

number of Passes

Mark this option to activate Passes