Product Info

• Click on Cut Now and a confirmation window opens where you have one more chance to note the Force

and Speed at which the material will be cut. Answer Yes to proceed, No to cancel:

• After selecting Yes, a Save PLT File window opens because earlier you had changed the connection type

to U_Disk. Browse to locate the USB flash drive you plan to use and name your PLT file:

• After saving the file, you can close the Vinyl Spooler window. Insert the flash drive into the right side of the

Skycut. On the control panel, select USB and then Open File:

Note where design

will cut relative to

where the blade

holder is positioned

Click on Cut Now

This figure assumes

blade holder is positioned

in the lower right corner of

the material

Locate the USB flash

drive for saving your files

Enter a file name

Click on Save