Product Info

• To reset the Skycut so that it will be found as an available network, press and hold the Default button for 3

seconds. Release and you should see the Apply button now displays Wait. In a minute the Apply should

return and you can then proceed back to A. The Skycut has never been set up wirelessly to a network and

use the same procedure as if the Skycut was never set up on a network.

1.12.4 USB Flash Drive

• With a USB Flash Drive connection, you will normally follow the steps presented in this section. If you are

new to SignMaster and/or to your Skycut, it is recommended that you go to Section 1.13 now and set up a

file using the steps presented there. Then, when you are ready to cut, return to this section.

• Insert a USB flash drive into your computer and allow Windows to find it. Note the drive letter assigned by

Windows.

• Design or open a file in SignMaster. After making any changes to the design, click on the Cut, Plot &

Engrave Tools icon (6

from the left on the upper middle task bar) and select Vinyl Spooler. In the

window which opens, click on the Connection tab and make the following changes:

• Click on the Cut Options tab:

Should read

SKYCUT C16

(or

the model you have

purcha

sed)

Select Windows

Port

Select Port

Select U-Disk