Product Info

1.12.3 Wireless Stand-Alone

• It’s usually best to connect the Skycut while it is next to the wireless computer. Once connectivity is

established, you can then experiment to see how far from the computer the Skycut can be located.

• There are two situations to consider before getting started. If you are not sure which applies to your Skycut,

then select B and go to that section first.

A. The Skycut has never been set up wirelessly to a network.

B. The Skycut has previously been connected to a wireless network.

A. The Skycut has never been set up wirelessly to a network

• Power on the Skycut and wait for the light to come on.

• On your computer, open your list of available networks. In the list, you should see one with this type of name

format: HI_LINK_XXXX where “XXXX” can be any alphanumeric combination, such as “92BF” or “08A5”.

• Select that network and enter the following Network Key when prompted: 12345678.

• In SignMaster, click on the Cut, Plot & Engrave Tools icon (6

from the left on the upper middle

task bar) and select Vinyl Spooler. In the window which opens, click on the Connection tab and make the

following changes:

• In the prior screenshot, the IP Address is already set to the correct Stand-Alone IP Address:

192.168.16.254. If this matches what you see, skip the next two steps. Otherwise, click on Configure and

the following window opens:

Should read

SKYCUT C16

(or

the model you have

purchased)

Select Windows

Port

Click on

Configure

Select Port

Check to see if this is

already set

Select TCP