Product Info

22
(4) To enter the password, use the following tips if you are unfamiliar with this type of screen:
◊ “Rapid tap” multiple times in succession to select a letter. For example, if your network password is
cts456, then to enter “c”, you would tap three times on “abc” because “c” is the third letter in “abc”.
Next you would proceed to “stu” and tap two times to enter “t”. Then you would only need to tap on
“stu” once to enter the letter “s.”
◊ To enter numbers, click on “123” to open the number entry screen.
◊ For punctuation, click on “#@~“ to open the extra characters screen.
◊ To enter upper case letters, click on the up arrow in the lower left part of the screen.
(5) Once you have the password entered in the display box at the top, click on OK to return to the Wifi
screen:
(6) Next check the IP Address that will be assigned to the Skycut. The Skycut will automatically pick up the
first three sets of digits from your router but will continue to display them as shown above. You only
need to decide if the last set, which should be defaulting to “200”, can be used. Use the “+” or “-“ buttons
to make any needed changes.
(7) Click on Apply and wait for several minutes while your router assigns this IP Address to the Skycut.
Eventually, you will see Connected OK appear:
Delete last
character
Password will
display here
Click OK when done
Toggle to switch between
uppercase and
lowercase letters
Switch to punctuation
Switch to
numbers
Default IP Address
assigned to Skycut
Click on “+” or “-“ buttons to
change
IP Address, if needed