Product Info

• Note that if your material is very wide, then it is fine to have the pinch wheels over the material. However,

you may need to be extra careful when removing any cut shapes or waste material in those locations.

1.10 Control Panel

• When you first turn power on the Skycut, after several seconds, the following Main Screen or Home

Screen will be displayed:

• Throughout this manual, the functions above will be referenced along with submenus and additional

screens. You will also see the following icons at the bottom of many screens. Pressing the one on the left

will always return you to the Main Screen above. Pressing the one on the right will return you to the prior

window/screen.

1.10.1 Set Screen

• Pressing the Set icon opens the Set Screen which contains access to many functions and settings.

Note the general description and section number (if you wish to learn more about that function now):

Repeat last cu

t. While cutting, this icon and function changes to Pause.

Open and cut PLT files from an

inserted USB flash drive

Execute a test cut using current

speed and force settings

Set the desired speed and force.

Toggle the speed for moving the head and

pinch rollers. In slow mode, the icon

changes to:

4 arrow keys for moving the

head left/right and for moving

the pinch rollers

Stop and cancel the

current cut

Change settings

Refer to

1.10.1

Go back to Main

Screen/Home Screen

Go back to prior screen

Middle pinch wheel is

und

er left-most arrow

Right pinch wheel is under

white arrow on right side.

Left pinch wheels is on

far left side (not in use)