Product Drawings

137
o Corner Style: Usually select either Round or Sharp depending on the nature of the original vector
and your desired contour
o Outline (%) or Outline (Units): Enter either a percentage or the actual size for the outline. In the
prior screeshot, leaving the Outline at 0 results in the contour being the same as the original
outside vector line. This would result in the same contour cut as was created in the prior Section
5.02.1. For an outset cut around the printed image, increase Outline to the desired size. For in inset
or inline cut, decrease Outline slightly so that it’s a negative number:
 Outline is set to 1/8 (0.125) inches:
 Inline is set to -1/32 (0.03) inches:
Select a Corner Style
Click on Accept when done
Use these options
Keep at 0 for cut line
to follow print line or…
Increase to add a
contour cut or…
Decrease to add an
inset cut
Click on View Mode to add the Outline preview
Outline set to 0.125”
Blue line shows size of
contour around original