Product Drawings

125
• Load the mat into the Skycut and be very precise in alignment by using the cutting strip to make sure the
mat is perfectly straight on both sides:
• Load the engraver into the Skycut using 15 Post-It notes, making sure the notes are on top of the tag.
• Move the cutting head so that the engraver tip is over the intersection of the two grid lines bounding the tag.
Then use the camera instructions in Section 2.05.1 to set the origin even more precisely by getting the blue
dashed + in the middle of the grid intersection:
• After clicking on Home, press down on the engraver and verify, once more, that the correct grid intersection
was used. Back in SignMaster, click on Cut Now and the engraving process will be carried out.:
Align the tag with the grid
lines on the mat
The origin will be set at this intersection
Blue dashed lines cross at
grid intersection
Align the mat on both sides
with the cutting strip