Product Drawings

92
(8) Depending on the print option selected in Step (6), the print button below the Preview will vary. Assuming
you selected Print Direct, you’ll see the option to Print. Click on it or click on the button in the same
location and then complete any popup window options as needed. Note that if you’ve already printed your
project, you will want to click on Skip instead:
(9) Place the printout onto the cutting mat or load the printout directly if a cutting mat isn’t required. Note that in
SignMaster, a print and cut project is loaded “upside down” as shown in the following screenshot. On the
printout is a small arrow which is a reminder to load the printout so that the little arrow is facing towards you
as you are facing the Skycut:
(10) Load the mat and/or printout so that it is straight, relative to the cutter. The alignment doesn’t need to be
absolutely perfect but close enough that it will allow for a faster and, of course, successful detection by the
camera. Insert the blade holder and perform a test cut, as needed, adjusting the cut settings.
Before applying Center
After applying Center
Click on Print. Note: the
wording on this button will
vary based on print option
selected in Step (6)
Click on Skip if project
is already printed
Small arrow should
point downwards
Place printout this direction on mat or,
if no mat is used, this direction as fed
into Skycut
Feed this direction into
Skycut