User's Manual

SkyBitz GLS 400/410 Mobile Terminal Battery Replacement Procedure
SkyBitz GLS 400/410 Mobile Terminal Battery Replacement Procedure Version 1.3
12 March 2010
Procedure
1. Loosen the two battery door/tray screws, using a T10 TORX screwdriver or equivalent. The screws are
captive and will stay attached to the battery door/tray.
2. Using your fingers, carefully pull the battery door/tray unit out of the MT. This may be difficult due to the
tight fit of the door and the dual O-ring seals. DO NOT ATTEMPT TO PRY THE DOOR AWAY FROM THE
MT HOUSING USING A SCREWDRIVER or SIMILAR OBJECT. Set the battery door/tray aside being
careful to keep the two “O” ring seals protected from dirt or other contaminants. Do not allow contaminants
to get inside the MT through the battery access area.
TORX SCREW LOCATIONS