Installation Instructions
x3
9. Next, conirm that the LED light is on and starts to blink red.
It may take a few seconds for the blinking to start. If the light
is blinking slowly, the SkyBell’s batery is charging, which
may take up to 10 minutes to complete. If
the LED light is blinking quickly (at a
rate of once per second), the device
is charged and ready to sync.
10. The set screw is already
in place in the botom-center
hole of the mouning plate.
Place the SkyBell completely
over the mouning plate and
insert the locking tool into
the middle hole at the botom-
center of the device. Turn
the tool counter-clockwise
(right to let) 3 full rotaions. This will draw the set screw
down and lock the SkyBell into place. Be sure that the
screw is not exposed beyond the botom of the device.
11. Your SkyBell is now properly installed.
12. Before staring the syncing process, please give SkyBell
10 minutes to charge the batery.
11
12