Installation Instructions

4. Secure the mouning plate to the wall with the two wall

screws. If you have stone, brick or drywall, drill holes with

the correct drill bit for your surface and use the screw

anchors to secure the screws to the wall.

Correct Drill Bit Sizes:

1. Masonry: 3/16”

2. Wood: 9/64”

3. Steel: 9/64”

Warning!

If you do not use a door chime, you must use a 10 Ohm / 10 Wat

resistor with one connecion between SkyBell and the power

source. Failure to do so could damage your device and will

automaically void your limited warranty. For more details:

www.skybell.com/support/power and ww w.skybell.com/legal

Instead of drilling into your wall,

you may use an outdoor adhesive

to glue the mouning plate to your

wall or door frame.

5. Gently twist together

the ends of a SkyBell wire

and a home doorbell wire

as shown.

6. Next, insert the

joined wires into a

blue wire connector

and push unil the

wires reach the end

of the wire connector.

7. With a pair of pliers, clamp down on the wire connector and

crimp the wires together.

8. Repeat steps 5-7 with the other two wires.

Either wire from your SkyBell may be

connected to either wire from your

home.