Installation Instructions

3. WITHOUT A DOOR CHIME
Setup 1:
Primary Power;
Low-voltage transformer (10-36 VAC 10 VA); and
10 Ohm/10 Wat resistor inserted between one wire from the
SkyBell and one wire from the power source
Setup 2:
12 VDC power supply; and
10 Ohm/10 Wat resistor inserted between one wire from the
SkyBell and one wire from the power source
Warning!
Installing your SkyBell with an improper power coniguraion
will automaically void your Limited Warranty
(htp://www.skybell.com/warranty).
Warning!
Coming into contact with a transformer can cause injury or loss
of life. Use extreme cauion when installing SkyBell.
OR
3
INSTALLATION INSTRUCTIONS
1. To begin, press your
current doorbell buton
to make sure your exising
door chime works.
2. Remove your tradiional
doorbell and carefully detach
or cut the 2 wires currently
connected to your tradiional
doorbell.
3. Run the wires through
the center of the mouning
plate. Be sure the front side
of the mouning plate
faces you.
7
8