Specifications

Notes:
The Alarm.com T r i m I I P r o
Doorbell Camera will flash Blue before it flashes Yellow –
do not release during the flashing Blue phase (this will power
cycle the device). You can factory reset the device when it is in AP
Mode (see instructions above). Press and HOLD the Main Button
until the LED flashes Yellow. If a factory reset is performed on a
camera that is already connected to Wi-Fi, the camera will need to be
re-installed to
re-establish its Wi-Fi connection.
Warning：
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
FCC warning:
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.