Specifications

If the LED is flashing Orange, the doorbell needs to be manually placed into
AP mode. Press and hold the Main Button until the LED begins rapidly flashing
green, then release. The LED will flash green as the Doorbell Camera scans
the Wi-Fi networks in the area. The Doorbell Camera should enter AP Mode
after a couple of minutes and the LED should begin alternating Red and
Green.
Enter AP Mode (Broadcast Syncing Mode)
Press and HOLD the Main Button until the LED begins a GREEN rapid strobe
flash, then release the button. When the LED flashes Green, it means the
Alarm.com Wi-Fi Doorbell Camera is in the process of entering AP Mode.
The LED will alternate Red and Green when the device has entered AP Mode.
Power Cycle
Press and HOLD the Main Button until the LED begins a Blue rapid strobe
flash. The power cycle could take up to 2 minutes.
Note: You can power cycle the Alarm.com T r i m I I P r o
Doorbell Camera when it is in AP Mode (see instructions above).
Press and HOLD the button until the LED flashes Blue.
Factory Reset
Caution: If you initiate a Factory Reset, the Doorbell Camera will need to
be re-connected to Wi-Fi and resynced with the account.
Press and HOLD the button until the LED begins a Yellow rapid strobe flash.
The reset could take up to 2 minutes.
Wi-Fi Connectivity
Online Resources
Visit alarm.com/doorbell for troubleshooting tips, installation videos
and more
CAN ICES-3 (B)/NMB-3(B)