Operation Manual

REMOTE CONTROL
TV TO FIT YOUR LIFE 57
If the setup didn’t work
If you followed the setup carefully but can’t see the TV Guide menu at the end of it, follow these simple steps:
1 Check and make a note of which TV channel you use for watching Sky digital TV.
2 Press tv on your remote control.
3 Hold down select and the green key together until the red light on your remote control blinks twice (this is after about 2
seconds).
4 Key in the number your TV uses for watching Sky digital TV and press select.
The red light blinks, meaning the remote control settings are made properly.
Alternative setup
If your TV’s brand isn’t listed on page 56, you can try an alternative setup. This involves programming your remote control to the TV’s
specifi c model code instead of the brand code, as follows:
1 Firstly, you need to check the code for your TV model:
Go to Interactive > Sky Active > Customer Support > Set Up Your Sky Remote.
2 Follow the relevant options until you get to the code for your model number then make a note of the code.
3 Point the remote control away from the TV and Sky
+
box and press the tv key.
4 Press and hold the select and red keys together until the red light blinks twice.
5 Enter the code. If it’s a 3-digit number, press select after the code.
6 Press Sky to complete the setup.
7 Now check the settings; point the remote control at the Sky
+
box and press tv then number 3.
You should now be able to see a terrestrial TV channel.
If you have tried these options and still can’t use your Sky
+
remote control with your TV, call Sky Customer Service.