Owner manual

2
INTRODUCTIONS FOR USE
1. IfthermwareversionofyourSynScan®handcontrollerisearlierthanversion3.32,you
shouldupdatethermwaretoversion3.32orlater.RegardingtheSynScan™rmware
update procedure, please read the SynScan® Instruction Manual.
2. IfthermwareversionoftheSynScan®handcontrollerisversion3.32orlater,yourhand
controller is ready to be connected to SynScan® GPS mouse.
3. Plug the RJ-12 connector on the end of the adapter cable into the RJ-12 socket of the
SynScan™ hand controller as shown in Fig.2.
First connect the adapter cable to SynScan® GPS mouse. (Fig. 1)
Fig. 1
Fig. 2