Owner manual

7
INSERTING EYEPIECE (Fig.14)
1) Loosen the thumbscrews on the end of the
focus tube.
2) Insert the diagonal into the focus tube
and re-tighten the thumbscrews to hold
the diagonal in place.
3) Loosen the thumbscrews on the diagonal.
4) Insert the desired eyepiece into diagonal
and secure by re-tightening thumbscrews.
INSERTING EYEPIECE (Fig.13)
1) Unscrew the thumbscrews
on the end of the focus
tube to remove the
black plastic end-cap.
2) Insert the desired
eyepiece then
re-tighten thumb
screws to hold the
eyepiece in place.
(reector)
(refractor and Maksutov)
EYEPIECE ASSEMBLY
ATTACHING THE FINDERSCOPE (Fig.10, 11)
1) Locate the nderscope optical assembly.
2) Remove the two knurled thumbscrews near
the end of the telescope main body. (near the
front of the telescope main body for the reector)
3) Position the nderscope bracket over the
screws in the telescope main body.
4) Secure the nderscope bracket with the
two knurled thumbscrews.
FINDERSCOPE ASSEMBLY
Fig.10 Fig.11
Fig.13
Fig.14
Fig.12
RED DOT FINDER ASSEMBLY
ATTACHING THE RED DOT FINDER (Fig.12)
Slide the red dot nder bracket into the
rectangular slot and tighten the screw to hold
the red dot nder in place.