User's Manual

9 10
Lens mark for camera positioning and leveler to align
and balance back plate. You can use Positioning Sticker
(included) to mark placement before adhering to your wall.
Refer to Option 1 to mount camera to wall with adhesive or
Option 2 to mount camera to wall with screws.
STEP 2 Mounting the camera’s back plate
After using the Leveler to adjust
the orientation of the plate,
adhere the Positioning Sticker
to mark the center of the plate.
Remove *adhesives from back
plate for a more stable placement
of the camera to the wall.
Align back plate with the
Positioning Sticker on the wall
to center the plate.
1 2 3
OPTION 1 Mounting with adhesive
Before installation, make sure the power switch is OFF or disconnect power at the fuse.
Refer to “What Is Included” in Section 2 for part installation for the steps below:
STEP 1 Socket installation
Install Smart Socket to fixture.
Attach USB Cable to
Smart Socket.
Thread in light bulb.
Reattach lamp
sconce if necessary.
Remove USB cover. Before
installing the socket into light
fixture, disassemble the lamp
sconce if necessary.
Screw lamp sconce back in and
drag out USB cable through the
shade then adjust Silicon sleeve
from USB cable to protect cable.
1
4
2
5
3
6
4. Toucan Installation
Positioning
Sticker
After using the Leveler to adjust the orientation of the plate,
you can use a pencil to mark the placement for the screws.
**Drill holes for screws placement. Install Wall Inserts.
Mount back plate with Washers and Screws.
* This 3M tape is strong and it may peel off wall paint, especially if the paint was not applied properly.
** Usual case in drywall or wooden.
* For 2 sockets pack, one socket is for backup purpose.
** Do not over tighten the scone screw during reattached scone, it may cause the wire break.
OPTION 2 Mounting with screws