Installation Instructions

45 mm 135 mm
78 mm
Charge your Battery Powered Security Camera
Open the back cover,
plug in micro usb cable
to charge the camera.
Setup your Battery Powered Security Camera
Press and hold the
SET button for 1s to
enter setup mode.
Open the APP
to add camera.
Following camera
voice navigation to
finish the setup.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance
20cm between the radiator and your body. This
transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC Compliance Statement available in the phone app at:
Settings > Legal & Compliance > Compliance
FCC STATEMENT
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including
interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le
présent appareil est conforme aux CNR d’Innovation, Sciences
et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée
aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.
This equipment complies with IC RSS-102 radiation exposure
limits set forth for an uncontrolled environment. This
transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
ce matériel est conforme aux limites de dose d'exposition aux
rayonnements ic rss-102 énoncées pour un autre
environnement.cet émetteur ne doit pas être situées ou
opérant conjointement avec toute autre antenne ou
l'émetteur.
IC CAUTION
Battery Powered
Security Camera
Battery Powered Security Camera as security
around your property. It can see any person at
your door or prevent crime wherever you go.
Items Included
Charging Cable
Wall Mount
Battery Powered
Security Camera
Get to know your Battery Powered Security Camera
Install your Battery Powered Security Camera
Magnetic
Base Mount
Camera
Lens
Microphone
PIR person
detection
LED indicator
SET button
Reset button
Micro SD
Speaker
Tripod screw hold
Mirco USB Plug
LBP01
Wall Anchors Screws
LBP01