User Manual

5
4
4
PREPARE YOUR ANAKIN
3
To your RX (Receiver) PPM & S.BUS
To your RX (Receiver) - DSM
For PPM & S.BUS please use black, red, yellow and blue cable.
YELLOW: Not used
BLACK: Ground
RED: +5V
BLUE: Signal
This instrucon is for seng up the inbuilt CC3D ight controller that comes with your ANAKIN FPV ARF.
If you use Sky-Hero Link 9 radio with its receiver go to page XX
Mount your receiver on the upper frame with double-sided tape.
Sky-Hero CC3D ight controller is only compable with:
 S-BUS receivers
 JR & Spektrum Satellite receivers
 PPM receivers
Please note that PWM (Pulse With Modulaon) is NOT SUPPORTED!
Pay aenon to bind your R (receiver) to your T (your radio) before connecng it to the Sky Hero CC3D Flight controler
Sky Hero CC3D
You will need to know exactly what kind of receiver you are using as dierent receivers request totally dierent setup steps. ANAKIN  FPs inbuilt
Sky-Hero CC3D supports 3 kinds of receivers: PPM, S.BUS and DSM.
PP PLSE POSIION ODLAION
A PPM signal (oen referred to as a PPM stream) is basically a series of PM signals (described above) sent one aer another on the same wire. So
instead of connuously sending the informaon for 1 channel or servo, the informaon for all servos or ESCs is sent in a row on the same wire. The
advantage of such a PPM signal is that only one signal wire is needed instead of all the individual wires.
For PPM receiver, the HITE and REY wire of the mul colored signal wire needs to be swapped FIRST, then connect the REY RED BLACK plug to
the PPM output of your receiver, no other wires need to be connected. See below:
S.BUS
The S.Bus is another communicaon protocol from Futaba that can also be used on other radios like Taranis and Radiolink. It also combines all output
channel informaon into single servo lead.
For S.Bus receiver, use the S.Bus signal wire and connect it to the S.Bus port on the main board, remove the mul colored PMPPM signal cable from
its socket.
DSSPEKRR SAELLIE ONNEION
Another receiver opon is the SpektrumR Satellite. It allows a SpektrumR or OrangeR satellite receiver to be connected to the CC3D.
For JR/Spektrum/DSM satellite receiver, plug the signal wire on the satellite to the DSM port on the main board. Then swap the ORANGE and BLACK
wire at any end of the plug. (see explanaon on next page)
USING LINK9 RADIO & RECEIVER
Please referr to the related chapter on page 14
STEP 1: CONNECT YOUR RX
signal cable from the
Wire 1 (black): Gnd/Negave
Wire 2 (red): Posive
Wire 3 (yellow): Not used
Wire 4 (blue): S.Bus Signal
NOTE: Only wire 1, 2 and 4 are used for the
S.Bus connecon. In our example that means
Black, Red and Blue - but colours may be
dierent for some cable.
one of the 4 wire cables.
«Input» socket.