User Manual
17
16
BEFORE TAKE OFF
1: OPERATE YOUR AIRCRAFT SAFELY
Refer to and follow all safety precauons menoned in the eneral Instrucons and uidelines for use secon of this manual.
Ensure that you always turn on your transmier before connecng the aircra baery power. Aer ying, make sure that you always disconnect the
aircra baery before turning o the transmier.
On the transmier, ensure switches are to neutral posion and the throle control is at the lowest posion.
Check that your aircra is ready for ight with no loose screws or ngs (pay special aenon to the propellers) insert a baery into the baery bay
and use the provided strap to secure the baery in place.
Connect the baery cable to the connector on the aircra.
(Important make sure you keep the aircra level and sll while connecng the baery)
ait for the LED lamp (located on the underneath of the aircra) to ash green rapidly it should do this twice (without a short interval between each
set of ashes).
You should wait unl the LED is only ashing reen without any Red ashes this indicates that you have sucient Satellites located for safe PS
mode ying. Beginners are strongly recommended to y in PS mode and become fully condent and capable with the aircra before ying in ATTI or
Manual modes
3: FLIGHT TEST YOUR ANAKIN
Fly minutes in hover and then land your aircra.
Disconnect the baery and check the temperature of the motors and tubes they may be warm, but must not be hot. Recharge the baery and check
the capacity (mAh) that your charger puts back into the baery. This mAh value will cor- respond to the power consumpon of your Anakin during the
minute ight.
4: CALCULATING YOUR IDEAL FLIGHT TIME
If for example you use a mAh baery and aer minutes of racing, you put it on charge and mAh of power is put back into the baery.
To translate this into your ideal ight me, you need to divide the capacity of the baery (mAh) by recharged mAh amount (mAh) and mul-
ply the result by the duraon of your ight in minutes ( min).
Example . x min 1 min 3. This is your approximate maximum ight me.
For safety reasons, we would advise that you do not y beyond more than of the maximum ight me.
In our example, if you y for about 1 minutes, you should have enough power to return and land without risking damage to your baery.
If your transmier has a countdown or a mer funcon, it is advisable to use it indy condions and cold temperatures can adversely aect your max
ight me.
Note You need to calculate the ight me individually for each typespecicaon of baery that you have.
STARTING AND STOPPING MOTORS
PSH OH ONROLS O ORNER POSIION
HIS AY E HANED IN OPENPILO SOFARE
STARTING SEQUENCE
MODE 2
12










