User Manual

16
15
7
- Now you can see your signal power level on your Link9 radio
Signal power level:
Lo id High
HOW TO CONNECT & BIND (with Sky-Hero LINK9 RX & TX)
FLIGHT MODES
1. STABILIZED SUPER SOFT: (ATTITDE MODE) - Switch 3 in P poson
Anakin comes back to a at posion when LEFT STICK is back to neutral posion - The maximal angle of the drone is ERY LIMITED.
2. STABILIZED SOFT: (ATTITDE MODE) - Switch 3 in MIDDLE poson
Anakin comes back to a at posion when LEFT STICK is back to neutral posion - The maximal angle of the drone is LIMITED.
3. RATE: (RATITDE MODE) - Switch 3 in DON poson
Anakin comes back to a at posion when LEFT STICK is back to neutral posion - The maximal angle of the drone is NLIMITED.
Then:
 Turn your Link9 on
 Plug your lipo in your model
 Push and hold the bind buon unl the Led start blinking
 Push again the buon again unl it starts blinking blue (meaning S.BS-
mode)
 Once the Led turns solid blue, its bound
BASIC COMMANDS
See hereunder how to control your Anakin.
T: it cannot hold the central posion when released.
Roll: it can return to the central posion when released.
Pitch: it can return to the central posion when released
Yaw: it can return to the central posion when released.
LEFT STICK RIGHT STICK
ODE 1
Pitch: it can return to the central posion when released
Roll: it can return to the central posion when released.
T: it cannot hold the central posion when released.
Yaw: it can return to the central posion when released.
LEFT STICK RIGHT STICK
 
ith Link9. you have to connect with the cable as shown on the picture.
(Yellow cable is not used)
To CC3D Flight
Controller «Main» port