User Manual

15
14

RADIO NAVIGATION SYSTEM
Push 2 sec to unlock screen
Push to enter or validate choice
Push to enter menu
Basic menu > advance menu > basic menu > etc...
- Enter basic menu
- Enter Model type
- Select -type- and change to
- Push 2x to validade
Push to exit
Signal power level:
LowM id
High
Dial
USING LINK9
FLIGHT MODE (C switch)
1. Stabilied Super So
. Stabilied So
3. Rate
CONFIGURATION PROCEDURE
This step is mandatory if you are using a LINK9
To use your Anakin ARF with your Link9 YO MST rst upgrade the Sky-Hero CC3D ight controller with the latest rmeware. To do so, you must
previously download the OpenPilot Soware (ERSION 1..) - see page  - and do the following
CHANGE MODEL TYPE
Discard the message warning you do not have the latest version by clicking
OK. Then click on the Firmeware Tab at the boom of the applicaon.
Then click on PRADE and wait unl the nalisaon of the process.
DO NOT click on «UPGARDE & ERASE». If you do so you will have to
go through the enre process 3  4 of the PREPARE YOR ANAKIN
chapter.