User Manual

11
10
Select Acro then click Next. Select the correct mode according to your transmier and click Next,
carefully follow the screen prompt unl the calibraon process is nished.
Make sure you fully understand the arming process and select the pre-
ferred arming combinaon under “Arming Sengs”. Dont forget to click
Save to save all the sengs.
Click “Atude” tab from the le, and make sure you put 1 into the
Roll seng. This is very important, failing to do so will cause an instant
crash on your rst ight.
Click “Flight data” tab from the boom bar, check the hud and make sure it
corectly reect all the movements of the ANAKIN.
WARNING:
PLEASE DO NOT MODIFY THESE SETTINGS UNLESS YOU
ARE FAMILIAR WITH CC3D AND KNOWS WHAT YOU ARE
DOING. SAVED MISCONFIGURE MAY CAUSE HARDWARE
ISSES THAT BEYOND END SERS REPARABILITY AND CAN
ONLY BE FIXED BY PCB REPLACEMENT.