User Manual

10
9
STEP 4: SETUP ANAKIN SETTINGS IN FLIGHT CONTROLLER
This step is mandatory if you’are not using a LINK9
Now the basic setup of CC3D is completed, you need to double check that everything is done correctly.
o back to OpenPilot homepage and click Conguraon tab at the bot-
tom and have a look at the H Sengs.
If you’ve chosen PPM receiver in the wiard
Click Hardware tab on le, check the Flexi Port and Main Port sengs
and make sure they are the same as on the screenshot. If theres any die-
rence please change accordingly and click Save.
If you’ve chosen S.Bus receiver in the wiard
Click Hardware tab on le, check the Flexi Port and Main Port sengs
and make sure they are the same as on the screenshot. If theres any die-
rence please change accordingly and click Save.
If you’ve chosen DSM receiver in the wiard, there are TO
things to check:
1. Click Hardware tab on le, check the Flexi Port and Main Port sengs
and make sure they are the same as the screenshot. If theres any die-
rence please change accordingly and click Save.
. Click Input tab on the le, and click RC Input tab you should see
the following page, double check if the contents under “Input Channel
Conguraon secon are the same as the screenshot below, If theres any
dierence please change accordingly and click Save.
Now its me to calibrate the radio, click Input tab on the le and click on Start Transmier Setup iard.
Accept the safety noce by click OK Click Next