Maintenance Manual

Maintenance Manual

phone model is available for sale to the public, it must be tested and certified to the FCC that it does not

exceed the limit established by the government adopted requirement for safe exposure. The tests are

performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for

each model. The highest SAR value for this model phone when tested for use at the ear is 1.131W/Kg and

when worn on the body, as described in this user guide, is 1.048W/Kg(Body-worn measurements differ

among phone models, depending upon available accessories and FCC requirements). While there may be

differences between the SAR levels of various phones and at various positions, they all meet the

government requirement for safe exposure. The FCC has granted an Equipment Authorization for this

model phone with all reported SAR levels evaluated as in compliance with the FCC RFexposure guidelines.

SAR information on this model phone is on file with the FCC and can be found under the Display Grant

section of http://www.fcc.gov/ oet/fccid after searching on

FCC ID: 2ABOSSKYROC Additional information on Specific Absorption Rates (SAR) can be found on the

Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com. * In the

United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg)

averaged over one gram of tissue. The standard incorporates a sub-stantial margin of safety to give

additional protection for the public and to account for any variations in measurements.

Body-worn Operation

This device was tested for typical body-worn operations. To comply with RF exposure requirements, a

minimum separation distance of 15mm must be maintained between the user’s body and the handset,

including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should

not contain any metallic components. Body-worn accessories that do not meet these requirements may

not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved

antenna.