Install Instructions

Attach the L-shaped bracket to the top/front of the humidier, so that the 4.

vertical wall is toward the reservoir.

Adjust the water level. (See Nos. 7 & 8 in “Plumbing and Setting the Water 5.

Level”, pgs. 11 & 12.)

Slide the anges of the humidier reservoir into the mounting bracket until 6.

the reservoir’s front ange comes in contact with the edge of the duct.

Secure the humidier to the duct with the screws provided. 7.

Option B requires a transition to be

made, and usually needs duct reinforce-

ment to hold the humidier securely in

place.

NOTE: For this conguration, the humidi-

er is mounted on the outside of the ple-

num, rather than the inside, so as not to

restrict airow.

DANGER: Wear safety glasses when

cutting or drilling. Do not cut or drill into

any air conditioning components or electri-

cal enclosures during installation. Elec-tro-

cution is possible if you come in contact

with a live electrical wire; blindness can

occur if refrigerant contacts your eyes.

To install (Option B):

Construct a transition and attach it to 1.

the plenum. (Additional humidier sup-

port will be necessary for this congura-

tion.)

Place the mounting bracket (provided) at the base of the transition. 2.

Use a marker to trace around the inside of the mounting bracket. Cut out 3.

the duct opening.

CAUTION: DO NOT attach the mounting bracket before the hole in the

ductwork has been cut.

Attach the L-shaped bracket to the top/front of the humidier, so that the 4.

vertical wall is toward the reservoir.

Figure 3—Option B:

External Side Mount

Figure 4—Mounting Bracket