User Guide
Page 10
FIGURE 9: Humidiîżer Frame
Mark and drill two or three of the mounting holes 7/64" (0.28 cm) in
diameter, and temporarily attach the mounting frame with #8 sheet
metal screws. Mark the remaining holes and center the opening, as
shown in Figures 10 (Model 55) and 11 (Model 86), below.
DANGER: Do not cut or drill into air conditioning or elec-
trical accessories during installation. Blindness can occur
if refrigerant comes in contact with your eyes; electrocu-
tion is possible if you touch a live electrical circuit.
2.
FIGURE 10: Model 55 Opening
FIGURE 11: Model 86 Opening