User's Manual

WIM1200-20 Configuration Manual
4
1 SSH Configuration
1.1 Default Username and Password
After launching the WIM1200-20 module, three SSID (AU-WIFI, AU-WIFI-1 and AU-
WIFI-2) would open and their passwords are the last 8 characters of the serial
number on module by default, which can be acquired in the label on it. Then the
SSID is searchable and connected by Wi-Fi terminal device.
The default SSH username is “admin” and the password is “5upS%k!”. Please see
the figure 1-1 below.
Figure 1-1 SecureCRT Login
1.2 Initial Password Change
The passward can be changed through passwd command “passwd admin”, then the
user can input the new password according to the note.
For further parameters change, please refer to the basic module configuration
command manual.