Datasheet

Applications
Single-pole safety connectors with 4 mm diam-
eter pins are suitable for measuring when mains
voltage or higher voltages up to 1000 V are be-
ing used. The enhanced contact protection pre-
vents short-circuits when working in the low volt-
age range and thus protects the user and high-
value equipment and devices that may be sensi-
tive to short circuits. Safety laboratory equipment
is used wherever contact protection is required
either by the safety regulations or just to prevent
accidents. It is used in laboratories, workshops
and, above all, in training institutions, where mains
voltage is being used.
Rigid sleeve system
The single-pole 4 mm diameter connector is en-
closed in a rigid plastic insulating sleeve which
cannot be pushed back. A suitable cutout is pro-
vided in the mating piece, the socket or a test
probe. In addition, the connector pin incorporates
an insulating cap. This prevents unintentional
contact from the side and from the front. The con-
nector is mechanically strong, robust and has
shatterproof insulation thanks to the crimp con-
nection techniques and the high-quality plastic
moulding.
Inspected connections
All products comply with the most recent safety
regulations such as IEC 1010, EN 61 010 and
VDE 0411. Products are inspected by the TUV
Sudwest and are approved in accordance with
the latest guidelines as specified in IEC1010
Versatile, reliable
High quality contact materials such as brass,
sprung nickel-plated copper beryllium connector
pins guarantee high security of contact. The wide
range of safety measuring equipment ensures that
the correct measuring tool is always available,
whatever the measuring task.
Important note
Safe working at voltages above protection volt-
age and low voltage makes great demands on
the measuring equipment, and also on the user.
Only conscientious, cautious working procedures,
the knowledge of the dangers and the safety regu-
lations and the use of the correct measuring
equipment can ensure maximum safety. The high-
est voltage to be measured is determined by the
weakest link in the chain.
We Will be very happy to advise you should you
have any questions regarding the possible appli-
cations, technical data or special designs of this
equipment.