User Manual

-9-
COMBINATION SQUARE MUST BE TRUE
Tools Needed for Assembly and Adjustment
1. Position square and
draw a light line
2. Flip square
(shown in dotted position)
3. Check edge of flipped
square against the drawn line.
There should be no gap or
overlap at the bottom end.
drawn line
3/4" board with
straight top edge
no gap or overlap
Disconnect plug from power source before performing any assembly, adjust-
ment or repair to avoid possible injury.
!
WARNING
Phillips & Flat Head
Screwdriver
10 MM Wrench Combination Square
Blade Wrench
(supplied)
2 MM Hex “L” Wrench
(supplied)
2610039875 12-15 E_SPT70WT 12/23/15 10:54 PM Page 9