User Manual

-12-
Unpacking And Checking Contents
To avoid injury from unex-
pected starting or electrical
shock during unpacking and setting up, do not
plug the power cord into a source of power.
This cord must remain unplugged whenever you
are working on the table saw.
Model SPT70WT Table Saw is shipped complete
in one carton.
Separate all parts from packing materials and
check each one with the illus tration and the list
of Loose Parts to make certain all items are ac-
counted for before discarding any packing ma-
terial (Fig. 3).
If any parts are missing, do
not attempt to assemble the
table saw, plug in the power cord or turn the
switch on until the missing parts are obtained
and are installed correctly.
REMOVE CABLE TIE AND
STYROFOAM BLOCK
(Used for shipping purpose only)
Turn saw over and locate the cable tie which
anchors the motor/blade assembly to the base.
Using scissors or wire cutters, cut and remove the
cable tie (Fig 4).
Release the blade tilt lock handle, tilt blade to 45
degrees, then remove styrofoam block located
between motor housing and table.
!
WARNING
!
WARNING
Operating/ Safety Instructions
Consignes d’utilisation/de sécurité
Instrucciones de funcionamiento y seguridad
1-
877-SKIL999 (1-877-754-5999) www.skilsaw.com
Call Toll Free for Consumer Information & Service Locations
Pour obtenir des informations et les adresses de nos centres de service après-vente, appelez ce numéro gratuit
Llame gratis para obtener información para el consumidor y ubicaciones de servicio
F
or English Version
S
ee page 2
V
ersion française
V
oir page 16
V
ersión en español
V
er la página 30
IMPORTANT
Read Before Using
IMPORTANT
Lire avant usage
IMPORTANTE
Leer antes de usar
SPT70WT
FIG. 3
6
5
4
1
2
7
3
FIG. 4
TABLE OF LOOSE PARTS
ITEM DESCRIPTION QTY.
1 Table Saw 1
2 Rip Fence 1
3 Table Insert 1
4 Barrier Guard Assembly 1
5 Anti-Kickback Device 1
6 Miter Gauge 1
7 Push Stick 1
8 Blade, 10” 1
9 Blade Wrench 1
10 Hex Wrench 1
11 Manual 1
9
8 1110
Remove
Styrofoam
Block
Remove
Cable Tie
2610039875 12-15 E_SPT70WT 12/23/15 10:54 PM Page 12