Use and Care Manual

-12-
!! 
Disconnect the plug from the power source
before making adjustments. Set depth
adjustment according to material to be cut.
Reconnect the plug to power source.
Hold the main handle of the saw with one
hand, tilt saw forward and rest front of the foot
plate on material to be cut. Line up the cutting
guide notch with the line you’ve drawn. Raise
the lower guard using lower guard lift lever
and hold the front of the foot plate with the
other hand. (Fig. 9).
Position the saw with the blade just clearing
the material to be cut. Start the motor and
once fully up to speed, gradually lower the
back end of saw using the front end of the foot
as the hinge point.
Once the foot plate rests flat on the surface
being cut, release the lower guard and move
the hand holding the front of the foot plate to
hold the auxiliary handle. Proceed cutting in
forward direction to end of cut.
225= (2'*+ :5)53+:5 '
)5362+:+9:56(+,58+2/,:/4-
:.+9'=,853);:2954+<+86;22:.+9'=
(')1='8*9/4)+(2'*+=/22)2/3(5;:5,:.+
3':+8/'2 '4*  =/22 5));8 Turn
saw around and finish the cut in the normal
manner, sawing forward. If corners of your
plunge cut are not completely cut through, use
a jigsaw or hand saw to finish the corners.
FIG. 9
FOOT
LOWER
GUARD LIFT
LEVER
LINE GUIDE
!
WARNING
When cutting is interrupted, to resume cutting:
s
queeze the trigger and allow the blade to
reach full speed, re-enter the cut slowly and
resume cutting.
When cutting across the grain, the fibers of
the wood have a ten den cy to tear and lift.
Advancing the saw slowly minimizes this
effect. For a finished cut, a cross cut blade or
miter blade is rec om mended.
! % 
T
his tool is not designed for use with metal or
masonry cut-off wheels.
545:;9+'(8'9/<+=.++29
=/:.)/8);2'89'=9(8'9/<+
*;9:3'?)';9+25=+8-;'8*:545:56+8':+
6856+82?
!
WARNING
!  
Large sheets and long boards sag or bend,
depending on support. If you attempt to cut
without leveling and properly supporting the
piece, the blade will tend to bind, causing KICK-
BACK and extra load on the motor (Fig. 10).
FIG. 10
WRONG
SM 1619X08870_SPT67W 7/24/14 2:21 PM Page 12