Use and Care Guide

Disconnect plug from power

source before performing any

assembly, adjustment or repair to avoid possible

injury.

NOTE: Your saw was completely adjusted at the

factory. However, during shipment, slight misalign-

ment may have occurred. Check the following set-

tings and adjust if necessary prior to using this saw.

Miter Scale Pointer Adjustment (Fig. 6)

1. Lock the saw head assembly in the DOWN po-

sition with the head assembly lock pin 19.

2. Lift the quick release lever 23 and pull the work-

piece clamp 15 away from the fence 21.

3. Loosen the miter lock lever 16.

4. Set the fence 21 to 0° position by placing the

combination square C between the blade 6 and

fence 21.

5. Lock the fence 21 in place by tightening the miter

lock lever 16.

6. Loosen the pointer adjust screw 17B that holds

the miter scale pointer 17A in place.

7. Position the pointer to align with the 0° line on

the miter scale 17C.

8. Tighten the pointer adjust screw 17B.

-12-

Adjustments

17C

17B

17A

FIG. 6

1609B00427 eng.qxp_SPT62MTC 5/12/15 1:53 PM Page 12