Use and Care Guide

-11-
&!$"
Wrench provided has several functions other
than loosening/tightening the blade bolt (Fig. 7).
1. Loosening/tightening blade bolt (1/2” wrench)
2. Loosening/tightening combo oil plug/lock
button assembly (1/2” wrench)
3. Loosening/tightening brush caps (slotted
driver)
4. Loosening/tightening bevel/depth levers
when levers are over tightened or additional
tightening is needed (9/16” wrench)
5. Blade diamond arbor knock out (wedge
feature)
Storage is provided on the tool (Fig. 1A).
Wrench is fully seated when second lock detent
is engaged.
&;.7,17..-<=8+.27<.;=.-
@2=1=1.,8;;.,=8;2.7=*=287
20 Damage to work piece could occur if
inserted incorrectly.
1
2
3
4
5
1/2" WRENCH
9/16" WRENCH
WEDGE
FEATURE
SLOTTED
DRIVER
CORRECT
INCORRECT
FIG. 8
FIG. 7
$
For a 0° cut, use the large notch in the foot.
For 45° bevel cuts, use the small notch (Fig.
6
). The cutting guide notch will give an
approximate line of cut. Make sample cuts in
scrap lumber to verify actual line of cut. This
will be helpful because of the number of
different blade types and thicknesses
available. To ensure minimum splintering on
the good side of the material to be cut, face
the good side down.
01
FIG. 6
FOOT
45° BEVEL
CUTS
0° CUTS
PUSH 45° STOP
SPRING IN
DIRECTION OF
ARROW FOR BEVEL
ADJUSTMENTS
ABOVE 45
D
45° STOP
SPRING
!
CAUTION
SM 1619X09194 09-14_SPT77W 9/12/14 7:01 AM Page 11