Use and Care Manual
13
OPERATING INSTRUCTIONS
WARNING
To reduce the risk of re, personal injury, and product damage due
to a short circuit, never immerse your tool, charger in uid or allow a
uid to ow inside them. Corrosive or conductive uids, such as seawater, certain
industrial chemicals, and bleach or bleach-containing products, etc, can cause a short
circuit.
DANGER
Never insert any part of the tool, including the bit, into an electrical
outlet for any reason. Never touch any portion of the tool to any
potentially live circuit. Failure to obey this warning could cause electric shock and other
serious personal injury.
WARNING
If any parts are damaged or missing do not operate this product until
the parts are replaced. Use of this product with damaged or missing parts
could result in serious personal injury.
To Charge the Battery
NOTICE: Charge before rst use. The screwdriver is shipped partially charged; fully charge
the battery before rst use.
Optimum performance can be reached by recharging the tool for about 3 hours. It is not
recommended that the tool for recharged for more than 24 hours after each use.
For use only with TENPAO S005ANU0500100 charger or Listed/Certied Information
Technology (Computer Equipment). (Max. Charging current: 0.7A; Max. Charging voltage: 5V)
WARNING
Never charge the tool with any charger or power source that is not
listed/certied. Failure to obey this warning could cause battery damage
and serious personal injury.
a) Insert the USB interface of the USB charging cable into the charger (not included).
b) Insert the charging plug into the charging port, making sure that they are properly
connected.
c) Connect the charger (together with USB charging cable) to the power outlet. The charging
indicator light will ash green to indicate that the tool is charging.
NOTICE: The tool will not run when the forward/reverse selector is rotated during charging.
d) When charging is complete, the charging indicator light will stay green. Remove the USB
charging cable from the tool.
NOTICE: The bottom of the tool may become warm during charging. This is normal.
NOTICE: Do not charge the tool in extreme hot or cold conditions. Charging is best achieved
at normal room temperature.
Fig. 2
(Not Included)