Use and Care Manual

10
OPERATING INSTRUCTIONS
WARNING
To reduce the risk of re, personal injury, and product damage due to
a short circuit, never immerse your tool or battery pack in uid or
allow a uid to ow inside them.
Corrosive or conductive uids, such as seawater, certain
industrial chemicals, and bleach or bleach-containing products, etc., can cause a short circuit.
WARNING
If any parts are damaged or missing, do not operate this product
unl the parts are replaced.
Use of this product with damaged or
missing parts could result in serious personal injury.
WARNING
Do not attempt to modify this tool or create accessories
not recommended for use with this tool.
Any such alteration
or modication is misuse and could result in a hazardous condition leading to possible serious
injury.
This cordless spot light must be used only with the battery packs and charger listed
below:
Battery Pack
Charger
2Ah 4Ah 5Ah
SKIL BY519701 SKIL BY519601 SKIL BY519603 SKIL SC535801
NOTICE: Please refer to the battery and
charger manuals for detailed operating
information.
To Attach/Detach Battery Pack
(Fig.2)
a. To attach the battery pack:
Align the raised rib on the battery pack with
the grooves on the tool, and then slide the
battery pack onto the tool.
b. To detach the battery pack:
Depress the battery-release button, located
on the front of the battery pack, to release
the battery pack. Pull the battery pack out
and remove it from the tool.
NOTICE: When placing the battery pack on the tool, be sure that the raised rib on the battery
pack aligns with the groove in the tool and that the latches snap into place properly. Improper
attachment of the battery pack can cause damage to internal components.
Fig. 2
Attach
Battery-Release
Button
Detach