Use and Care Manual

18
WARNING
Never aim the beam at a workpiece with a reective surface. Bright
shiny reective sheet steel or similar reective surfaces are not
recommended for laser use. Reective surfaces could direct the beam back toward the
operator.
CAUTION
Use of controls or adjustments or performance of procedures other than
those specied herein may result in hazardous radiation exposure.
CAUTION
The use of optical instruments with this product will increase eye hazards.
Using the guide notches without
laser line
For a straight 90° cut, use right side of notch
in the foot. For 45° bevel cuts, use the left side
(Fig. 7a). The cutting guide notch will give an
approximate line of cut. Make sample cuts
in scrap lumber to verify actual line of cut.
This will be helpful because of the number of
different blade types and thicknesses available.
To ensure minimum splintering on the good
side of the material to be cut, face the good
side down.
Wrench storage
Wrench storage is provided on the tool (Fig.
3). Wrench is fully seated when second lock
detent is engaged.
CAUTION
Wrench needs to be
inserted with the correct
orientation (Fig. 8). Damage to work piece
could occur if inserted incorrectly.
Power indicator light
When you plug your tool into the power source, the power indicator light will go “ON” indicating
the tool is receiving power (Fig. 1).
Safety switch
The safety switch is designed to prevent accidental starts. To operate safety switch, press
the release button with your thumb on either side of handle to disengage the lock, then pull
the trigger (Fig. 1). When the trigger is released the button will engage the safety switch
automatically, and the trigger will no longer operate. (See SWITCH and GENERAL CUTS.)
Fig. 7a
45°
Bevel
Cuts
90°
Vertical
Cuts
Fig. 8
Correct
Incorrect
Foot
Blade
Wrench