Operating Guide
FIG. 1
FIG. 2
FIG. 3
)$$!('&*'
10 mm Wrench
OR 10 mm Socket
Phillips Screwdriver
Adjustable End Wrench
Straight Edge
"$!$#!.
$'.$*(("!)(-)#($#)$
"$!)!(,
Sort out and account for all parts to make sure that you have all
necessary materials to assemble your tool exten sion. Do not
discard packing material until all parts are accounted for (Fig. 2).
ITEM DESCRIPTION QTY.
1. Table Extension 1
2. Hex Head Bolt — 1/4-20 x 1 1/4" 2
3. Hex Nut — 1/4-20 2
4. Lockwasher 2
5. Flat Washer 4
6. Hex Head Leveling Screw 2
7. Scale 1
!%*!(("!.#)(
Assemble nuts and bolts finger tight only until completely
assembled as adjustments may be necessary.
This part may have sharp edges. Be careful in
handling to prevent being cut.
-)#($##()!!)$#
1. Place extension along desired side of table saw.
2. Place flat washer and hex head bolt through holes at each
end of table and extension.
3. Place flat washer , lockwasher and hex nut onto hex
head bolt as shown. Finger tighten nut.
4. Tighten hardware just enough to allow adjustment of extension.
5. Using a straight edge, adjust extension to be flush with table
along top surface and front edge.
6. Tighten nuts securely.
7. Recheck with straight edge.
WARNING
!
SM 2610947705 7-09:SM 2610947705 11-06 7/9/09 2:13 PM Page 62