Operating Guide
1
FIG. 8
FIG. 9
FIG. 10
2
3
4
39DBC<4=CB
;034)8;C8=6>=CA>;
Loosen blade angle lock counterclockwise (Fig. 8), slide the
e
levation wheel until blade is at desired angle and tighten blade
angle lock clockwise.
39DBC8=60=3
46A44%>B8C8E4(C>?B
Your saw is equipped with positive stops for fast and ac curate
positioning of the saw blade at 90 (0°) and 45 degrees to the table.
To prevent personal injury, always dis con nect
p
lug from power source when making
adjustments.
*()#%$()+()$%)'(
1. Turn elevation wheel clockwise and raise blade to maxi mum
height.
2. Loosen the blade angle lock and push the elevation wheel
to the left as far as possible and tighten the blade angle lock .
3. Place a combination square on the table with one end of square
against the blade as shown (Fig. 9), and check to see if the blade is
90 degrees to the table. If the blade is not 90 degrees to the table,
loosen the blade angle lock, loosen 90 degree adjustment screw
a few turns and push the elevation wheel until the blade is 90
degrees to the table. Then tighten blade angle lock and tighten 90
degree adjustment screw until it stops.
4. Adjust pointer to indicate 0 degrees.
*()#%$()+()$%)'(
1. Loosen the blade angle lock and push elevation wheel to the
right as far as possible and tighten the blade angle lock .
2. Place a combination square on the table with one end of the
square against the table as shown (Fig. 10), and check to see if the
blade is 45 degrees to the table. If the blade is not 45 degrees to
the table, loosen the blade angle lock, loosen 45 degree
adjustment screw a few turns and push the elevation wheel until
the blade is 45 degrees to the table. Then tighten blade angle lock
and tighten 45 degree adjustment screw until it stops.
WARNING
!
SM 2610947705 7-09:SM 2610947705 11-06 7/9/09 2:13 PM Page 26