Operating Guide
If you are making a rip type cut in thinner materials, the facing
should be attached to the fence so that the bottom edge touches
t
he top surface of the table. In this situation, the facing must be
lower than the fence. This will prevent thin material from sliding
under the rip fence.
When positioning fence for maximum rip
cutting (without table extension), make sure side
of fence housing is even with the side edge of the table . Do
not make rip cuts or dado cuts beyond this position because the
fence can not be properly locked. Maximum rip cut capacity is 12
inches (Fig. 4).
!*'
Protects the operator, and must always be in place and working
properly for all thru-sawing cuts. That is all cuts whereby the blade
cuts completely through the workpiece.
)!#(')
Is removable for removing or installing blade or other cutting tools.
For your own safety, turn switch “OFF” and
remove plug from power source before re moving
insert.
To remove the insert:
A. Lower the blade below the table surface.
B. Raise blade guard.
C. Remove insert screws and lift insert from pocket in table.
Never operate the saw without the proper insert in place. Use the
saw insert when sawing, and the dado insert when da do cutting.
")'*
Head can be locked in desired position for crosscutting or mitering
by tightening the lock handle. ALWAYS SECURELY LOCK IT
WHEN IN USE.
Notches are provided in the miter gauge for attaching an
AUXILIARY FACING to make it easier to cut longer pieces. Be
sure facing does not interfere with the proper operation of the saw
blade guard.
Select a suitable piece of smooth straight wood 3/4" thick, drill two
holes through it and attach it with two round head #10 or #12 round
head screws 1-1/4" long (Fig. 6).
#$): When bevel crosscutting, attach facing so that it extends to
the right of the miter gauge and use the miter gauge in the groove
to the right of the blade.
4CC8=6)> =>F.>DA)01;4
(0F>=C8=D43
WARNING
!
WARNING
!
FIG. 4
21
22
FIG. 6
2
20
"-"*" #(
14
17
O
N
/
O
F
F
I
N
C
H
/
M
M
Z
E
R
O
11
3
5
14
10
6
7
15
2
13
16
FIG. 5
13
14
8
9
17
SM 2610947705 7-09:SM 2610947705 11-06 7/9/09 2:13 PM Page 22