Operating Guide
O
N
/
O
F
F
I
N
C
H
/
M
M
Z
E
R
O
11
3
5
14
10
6
7
15
2
13
16
FIG. 1
12
FIG. 2
18
19
FIG. 3
4CC8=6)> =>F.>DA
)01;4(0F
%$,'(,)
Has a design feature allowing the tool to be locked in the OFF (“O”)
p
osition (See page 38 & 39).
)!
Provides large working surface to support workpiece.
(
Supports table saw. For additional stability, holes are pro vided in
base to bolt the saw to a workbench or stand.
!#!!$
Locks the tilt mechanism after the blade is adjusted to de sired
p
osition.
!+)$#,!
Elevates or lowers the blade at all angles from 0 to 45 degrees.
!)!)(!
Shows the degree the blade is tilted.
'%#(!
Shows the distance from the blade to rip fence.
)!X(%!.
Allows you to choose and convert measurements in inches or
millimeters for table saw operation.
")'*(!
Shows the degree the workpiece is being mitered.
'%#()$'
Conveniently stores rip fence on two pads on the left side of base
when not in use. Simply align hole on fence with locating pin on
front pad, and press fence down into it’s storage position as shown.
")'*()$'
Conveniently stores miter gauge on the right side of the base when
not in use. Simply insert miter gauge bar into rectangular hole on
right side of base, and push the miter gauge fully into it’s storage
position as shown.
!,'#()$'
Conveniently stores two 10” blades, hex wrench, & arbor wrench.
$','%
Allows you to easily wrap up the cord so it’s out of the way when
transporting or storing.
'%#
Exclusive Self-Aligning, Quick-Set rip fence can be easily moved or
locked in place by simply raising or lowering lock handle.
Holes are provided in the rip fence for attaching a wood facing
( Fig. 3). Wood facing should be used when making cuts using
dado blades, or ripping thin materials.
Select a piece of smooth straight wood approx. 3/4" thick and the
same size as the rip fence.
Attach it to the fence with two round head No. 10 wood screws 1- 5/8"
long (Fig. 3).
13
14
14
8
9
17
SM 2610947705 7-09:SM 2610947705 11-06 7/9/09 2:13 PM Page 20