MSDS

LL Ⅲ
技 猥 $嚣 跟
・
aˉ图
8Υ D C0MPANY LIMlTE【 ,
7. Handling
and Storage
9. Physical and
Chemical
Properties
舀
Handling The
cells and batteries manufactured from
them
may
be highly charged
and
are capable of high-energy
discharge. Care
should
be taken to handle
cells
properly
to avoid shorting or misuse
that
will
result in rapid
uncontrolled
electrical, chemical,
or
heat
energy release.
Do
not short circuit. Do not
dispart cell.
Do
not allow an exposed flame
or
spark
to
come
near the cells. Do not mix new and
used batteries. Keep
batteries in non
conductive travs.
Storage The
cells and batteries
shall
not be
stored
in high
temperature, the
maximum
temperature is
60C(less than one month), otherwise
the cells
and batteries maybe leakage. Besides,
the
cells and
batteries shall be
protected
from
short circuit and
protected
from movement
that could result
in short circuit.
Other Follow manufacturer's
recommendations regarding
maximum
recommended currents
and operatinq temperature
ranoe.
8. Exposure
Gontrols
&
Personal
Protection
Exposure Limit
Values
Nickel
compounds: 0.5m9/m3 TWA
Cadmium
compounds: 0.01m9/m3 TWA
Potassium hvdroxide: 2mqlm3 MAC
Respiratory
protection
Use NOISH/MSHA
approved respirator if
cell broken open during a
fire to maintain
exposure levels below the
TWA for
cadmium and
nickel
compounds.
Hand
protection
lf
exposure to electrolyte solution,
or
dried salts is likely,
use any
water-insoluble
non-performance
glove,
i.e., synthetic rubber. Do not
use leather
or wool.
Eve orotection
Use splash
qoqgles
or face
shield
if cell activates due to abuse.
Other
Rubber apron or
equivalent
if
exposure to electrolyte solution is likelv.
ADDearance
Sealed batterv
Odour Odourless
Co丨or N`A
PH N`A
FIash Point
N/A unless individual
components exposed
F丨arnrnabi丨Ⅱ
v N/A unless individual
comoonents
exoosed
R丨ate犭Ve densitV
N/A
unless
individual
components exposed
sdutbi丨
itV№
ater)
N/A unless individual
components
exposed
AOIubⅢ tvfothen
N/A unless individual
components exposed
10.stab"ky and ReⅡ ab"△
y
stabi丨ity
Stable under normal conditions
Condition to avoid Keeo
awav from heat and sources of
iqnition
Materialto
avoid Aluminum,
zinc and
other
active metals, acid, chlorinated
and
a romatic hvdroca
rbons.
n itro-ca rbons. ha loca rbons. Water.
Hazardous
Polvmerization
Hozardous Po丨
ymeHza刂
on does not occur
Hazardous
decomposition
Products
Cadmium compounds, nickel
compounds,
carbon oxides
Approved By: