- Sea-Doo 2009 Jet Ski Operator's Guide

STORAG E AND PRESEASON PREPARATION
smo2008-001-054_a
1. Flushing connec tor — location may differ
The following hos e can be fa brica ted to
ease draining procedure.
smo2008-001-053_a
TYP ICAL
1. Flushing connect or adapter
2. Hose 12.7 mm (1/2 in)
3. Air hose male adapter
NO TICE
Failure to drain t he ex-
haust system may cau s e sever e
damage to the intercooler (super-
charged mode ls) and exhaust m ani -
fold.
Engine Internal Lubrication
Pull e ngine cov er upwa rd to remove it.
Disconne ct ignition coi l connectors.
WARNING
When disconnecting coil from
spark plug, always disconnect coil
from main harness first. Never
check for engine ignition spark
from an open coil and/or spark
plug in the engine compartment
as spark may cause fuel vapor to
ignite.
IMPORTANT: Never c ut the lo cking
ties of ignition coil conne cto rs. This
would allow mixing the wi res b etween
cylinders.
Remove igni tion coils.
NO TICE
Ensure there is no dirt
in coil holes prior to removing the
spark plu gs. Otherwi se , dirt would
fall into cylinder and will damage
the internal components.
Remove spark plugs.
NO TE: After loosening the spark
plugs, a coil m ay be used to pull the
spark plugs out. Simply bring the coil
down to spark plug and "hook " i t to then
extract spark p lug.
smr2006-016-030_a
1. Ignition coil
2. Spark plug
Spray X P-S Lube or e quiva lent, in s pa rk
plug holes.
To prevent fuel to be inj ec ted and also
to cut th e ign ition at the engine crank-
ing, proceed as follows .
While engine is stopped, fully depress
throttle lever and HOLD for cranking.
Crank the e ngine a few turns to distrib-
ute the oil on c y linder wall.
Apply anti-seiz e lubricant on spark plug
threads then reins tall them.
NO TE: P rior to inserting the i gni-
tion coil to its locat ion, appl y som e
Molykote 11 1 grease (P/N 413 7 07
000) around the seal area that touches
the spark plug hole. After installation,
ensure the sea l seat s p roperly with the
engine top s urface.
_______________
95