- Sea-Doo 2009 Jet Ski Operator's Guide

CONTROLS/INSTRUMENTS/EQUIPMENTS
6. A djust trim to the desired positi on
using VTS buttons.
7. Push both VTS buttons a ga in s imul-
taneously to rec ord trim position.
Trim pre-set positions are recorded and
readytobeused.
To record new settings, repe at proce-
dure.
Using P re-Set Trim Positions
To set trim to the highest trim position
recorded, double-click on VTS upper
button (bow up).
To set trim to the lowest trim position
recorded, double-click on VTS lower
button (bow down).
If trim s etting is unique (one position),
double-click either o n the lower or up-
per VTS button.
smo2008-001-010_c
DOUBLE-CLICK TO USE PRE-SET
POSITIONS
Shift Lever
A push-p ull lever:
– Forw a rd
– Neutral
– Rev ers e.
WARNING
Shift lever should only
be used
when the engine is idling and wa-
tercraft is completely stopped. Do
not use as a grab handl
e.
WARNING
Only use reverse at sl ow speed
and for the sh ortest time possib le.
Always ensure the path behind
is clear of objects and persons in-
cluding children playing in shallow
water.
NO TICE
Neverrevtheengineat
high RPM in rever se.
From the forward position, pull the
lever to revers e. Push b ack to go to
forward. Always set in forward when
finished. To find the neutral, set in re-
verse then push back until the water-
craft stops moving backwards.
Refer to
PRINCIPLE OF OPERATION in
OPERATING INS TR UC TIONS section
for the description of the propulsi on
system.
smo2008-001-012_a
TYP ICAL
1. Shift lever
2. Forward p osition
3. Neutral position
4. Reverse position
Inform ation C enter Gauge
Multifunction gauge that supplies s ev -
eral rea l time useful information to the
driver either in English, French or Span-
ish. See an authorized Sea-Doo dealer
for unit settings.
At start-up, all LC D segments and indi-
cator lights will turn on for 3 s ec onds
each time the in form ation center is
46
______________