- Sea-Doo 2009 Jet Ski Operator's Guide

PRE-RIDE INSPECTION
Hull
Inspect hull for cracks or damage.
Jet Pump Water In take
Remove weeds, shells, d ebris or any-
thingelsethatcouldrestricttheflow
of water and damage propu lsion unit.
Clean as necessary. If any obstruction
can not be removed, refer to a n autho-
rized Sea -Doo dealer for servicing
F18J04Y
21
TYP ICAL — INS PECT THESE AREAS
1. Water intake
2. Ride plate
WARNING
When operating t he engine while
the watercraft is ou t of the water,
the heat exchanger in the ride plate
may become very hot. Avoid any
contact with ride plate as burns
may occur.
Bilge
Should water be presen t in the bilge,
tilt the watercraft to the rear and un-
screw drain plugs to completely em pty
the bilge.
Secure bi lge drain plu gs.
WARNING
Make sure drain plugs are properly
secured prior to launching the wa-
tercraf t in water.
Battery
WARNING
Verify tig htness of battery cables
to their posts and condition of bat-
tery retaining fasteners. Do not
charge or boost battery while in-
stalled.
All M ode ls Exce pt GTI and RXP
Battery is located under seat in b ilge.
1
F18H0AY
TYP ICAL
1. Battery
GTI and RX P Model s
Battery is located u nder storage bin i n
front storage c om partm ent.
34
_______
SAFETY INFO RM ATION
________