Users Manual

1.5 Charging the battery
The Microlog dBX is designed to run continuously for 8 to 10 hours with a
pair of fully charged batteries. When you turn on your Microlog dBX, you
can see the condition of the battery power gage at the top right corner of
the screen.
To charge your Microlog dBX, plug the connector of power supply to the
7-pin connector (TRIG/PWR) of Microlog dBX. The power supply unit
accepts 100 ~ 200 V AC power. During the charging process, if you turn
on the instrument, you’ll see that the battery power gage scrolling. It is
normal that the casing of the instrument gets a little bit warmer during
charging.
You can extend the operational hour in the field by replacing the battery
with a backup one. Besides, if you plan to use the instrument within 4
hours, you can use only one battery to reduce the weight.
Handle battery packs carefully
This product contains a Li-ion battery. There is a risk of fire and burns if the
battery pack is handled improperly. Do not attempt to open or service the
battery pack. Do not disassemble, crush, puncture, short external contacts, or
circuits, dispose of in fire or water, or expose a battery pack to temperatures
higher than 60˚C (140˚F).
Power
Supply
100 ~ 240 Vac