Users Manual

2.2 DAQ Menu
Select the DAQ button from the main menu to enter the DAQ display.
In this page you can conduct testing on the instrument’s data acquisition
hardware or reset the hardware when necessary.
Reset
Select the Reset option will disconnect and reconnect the data acquisition
hardware (DAQ) via the GPIO device inside. You can conduct the DAQ reset
to restore hardware connection when the Microlog dBX loses connection to
the DAQ hardware.
Test
Select the Test function to enter the test page and perform fundamental
testing on the DAQ hardware. This page provides you with oscilloscope
display to verify the working condition of your DAQ hardware. The TEST
function could be useful when you need to verify whether you hardware is
working normally.
You can set the bandwidth, select the measurement channels, select coupling
mode and input range to conduct measurements.