User manual

CARE/MAINTENANCE
12-3
Check the batteries frequently for signs of corrosion. If corrosion is evident, clean terminals with a baking soda
and water solution and a wire brush. Before cleaning, remove the vent caps and seal the vent wells with corks to
prevent the solution from getting inside the battery.
NOTE
Some batteries are sealed and cannot be filled.
Check the fluid levels in the cells. Usually, a level approximately 1/4 to 1/2 inch (6 to 13 mm) above the plates is
sufficient. If needed, fill with distilled water. DO NOT overfill!
• Batteries contain sulfuric acid which can cause severe burns. Wear
protective clothing to avoid acid contact with your skin and eyes. Failure to
do so could result in severe injury.
• The battery compartment doors MUST be secured in the open position for
ventilation when charging any batteries.
• Be sure to inspect your boat for and eliminate fuel fumes and their cause
prior to connecting a battery charger to your batteries.
WARNING
Section 12_horiz 11/3/03 2:45 PM Page 12-3